How can I automatically run a command after an application closes?

[katykaty]

Norton Ghost installs a windows xp service, which I assume controls its backup scheduler. But I start my backups on demand so don't need it.

The problem is, if I stop the service through WinPatrol, Ghost just starts it again next time it runs. 

I've discovered I can use

[Select]

sc stop "norton ghost"

to stop it - so is there any way I can make that command automatically happen once Ghost has completed its shutdown?

Thanks 

[gjehle]

if you'd start an executable that wont finish till it's done you can write a batchfile

[Select]

commandA
commandB

[katykaty]

Thanks - I'll try that