Recent Posts

1

DesktopCoral / Re: Settings are not saved.

« Last post by timmiejboy on May 01, 2011, 03:50 AM »

// NOTE: you have to *remove* the // in front of one line below to activate it
// This will effect the location of both settings files AND the database files

// CONFIGDIR = .
// CONFIGDIR=%MYDOCUMENTS%


// This file (ConfigDir.ini) defines the directory where all configuration
//  files for the program will be stored.
// There should be only 1 actual line in this file that has any meaning,
//  the CONFIGDIR assignmane above.  Everything else here is just comments.

(...)

This is a part of the ConfigDir.ini as it was before I fixed it.

// NOTE: you have to *remove* the // in front of one line below to activate it
// This will effect the location of both settings files AND the database files

CONFIGDIR = .
// CONFIGDIR=%MYDOCUMENTS%


// This file (ConfigDir.ini) defines the directory where all configuration
//  files for the program will be stored.
// There should be only 1 actual line in this file that has any meaning,
//  the CONFIGDIR assignmane above.  Everything else here is just comments.

(...)

I removed the comments in front of the red line. Which places the settings in the actual program directory according to Tip 2.

Cheers

2

DesktopCoral / Re: Settings are not saved.

« Last post by timmiejboy on April 29, 2011, 05:45 AM »

Thanks for the heads up. I got it fixed.

The ConfigDir.ini was a complete comment.
So // went prior to every line in the document, while the document said there should be one line that was not commented.

So I removed the comment before the default directory path and now it's fixed.



Cheers

3

DesktopCoral / Re: Settings are not saved.

« Last post by timmiejboy on April 28, 2011, 11:27 AM »

If I start Desktop Coral, configure it how I want to, and then exit the program. It will once again be completely default after restarting it.

So it does NOT remember my settings after a restart.

4

DesktopCoral / Settings are not saved.

« Last post by timmiejboy on April 27, 2011, 03:34 PM »

I have been using DesktopCoral for a while now to reserve space for my Rocketdock. I am very happy about this beautiful piece of software.

I just have a slight problem with it ever since I installed a fresh install of Windows 7 x64.
Once I set all the preferences for the dock (eg. at the bottom, 62px height, startup with windows and transparant),
all is fine and it works perfectly.

Sadly, every time I reboot my computer the DesktopCoral dock loads itself undocked in the standard format somewhere in the middle of my screen with 100% opacity.

I am getting a bit tired of keeping to redock and reset all the stuff every single time I start up my computer.

Can anybody help?

Cheers,

Tim