DonationCoder.com Software > Screenshot Captor
Toolbar at screen top does not appear when Windows opens
hamradio:
Ah! The button with the red "X." I often use the button next to it; I must have hit the X by accident. Thanks again!
-tigerdg (May 30, 2024, 06:06 PM)
--- End quote ---
Tip: You can also disable the X if you want to be sure not to hit by accident. Uncheck the highlighted checkbox in my screenshot.
tigerdg:
Done. And thanks again. :)
tomos:
Learned something there - thanks :up:
AzureToad:
Is there an .INI or .CONFIG file that specifies the X/Y coordinates for where the Quick-Capture Bar is located? I've enable and disabled that item by right-clicking the systray icon, but it's not appearing anywhere for me. I have 3 monitors and have not changed the primary monitor nor resolution. I'm wondering if it's docking off-screen somewhere?
hamradio:
Is there an .INI or .CONFIG file that specifies the X/Y coordinates for where the Quick-Capture Bar is located? I've enable and disabled that item by right-clicking the systray icon, but it's not appearing anywhere for me. I have 3 monitors and have not changed the primary monitor nor resolution. I'm wondering if it's docking off-screen somewhere?
-AzureToad (July 12, 2024, 11:07 AM)
--- End quote ---
I don't think x/y coordinates exists but here is a check for you to make sure the value in screenshot isn't set to a low value (value of 0 = invisible as noted in the window) making it invisible to the eye. Even with that value at 0 if you hover over the correct place (should be the very top and the center of screen if docked to edge of screen) it will still show the bar it just wont show the place to hover to show it. Another to check is that last checkbox in quick capture bar portion of the settings page highlighted incase it is displaying off screen maybe docking it will get it to show back up if it is unchecked.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version