Main Area and Open Discussion > Living Room
Thread on 3d Printing Cody Model
mouser:
I wonder if I could print an 8" x 8" x 8" cody award..
KynloStephen66515:
I wonder if I could print an 8" x 8" x 8" cody award..
-mouser (April 04, 2018, 11:09 PM)
--- End quote ---
Print an 8' x 8' x 8' one...then I'll be impressed :P
mouser:
I printed out the 8"x8"x8" baby cody model.. The scaling up had a couple of issues.. the most serious one was I enabled supports and they kind of merged into the model, which has required some facial reconsutruction for baby cody. No cost was spared to give him a proper beak, but I will need to wait until he wakes up from surgery to determine whether it was a success. If so he will go in for painting and then have his photo taken..
ayryq:
I printed out the 8"x8"x8" baby cody model.
-mouser (April 07, 2018, 02:05 AM)
--- End quote ---
How long did it take? And how much filament?
mouser:
it took 21 hours. and a LOT of filament.. not sure how much.. maybe 1/3 to 1/4 of a spool?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version