Main Area and Open Discussion > Living Room
Printer printing fuzzy
kalos:
Hello!
I have a problem with my printer, it prints fuzzy. I was thinking that it's because it rests in an unstable surface, but even if I stabilize it, it stills print like that (doublis letters).
The printer is Canon MG6450 and I did both deep cleaning and realigning of the heads.
https://i.imgur.com/1dsofET.jpg
Any hint?
Thanks!
Contro:
It seems an inkjet printer.
Probably the head is in the refill of ink. This is probably damaged.
When you change the ink probably goes better.
kalos:
It is an inkjet printer.
Why changing the ink will get better and not by re-installing the ink?
Also it is strange that some lines are ok, and some other are fuzzy. Can this help to differentially diagnose?
mouser:
The most practical cure for a fuzzy ink jet printer these days is:
* Unplug the inkjet printer
* Place fingers under each side of the printer
* Lift printer about 3 inches off the table
* Rotate 180 degrees and carry the printer to the nearest trash can
* Release printer into trashcan
* Go online and order replacement printer
Inkjet printers are so cheap -- with the cost being mainly due to ink, that when an inkjet printer starts acting up, unless it is some serious pro-quality printer, your best bet is to buy a new printer and not waste ink on your old one.
kalos:
And I was about to literally follow the instructions! ;D
Navigation
[0] Message Index
[#] Next page
Go to full version