DonationCoder.com Software > Screenshot Captor

Turn off INI backups

<< < (2/3) > >>

mouser:
You said that it's using the backup instead of the latest -- is it possible instead that its merely resetting to all default options?
Second question: is it possible that this behavior only happens after restarting the computer?

lanux128:
You said that it's using the backup instead of the latest -- is it possible instead that its merely resetting to all default options?-mouser (September 03, 2013, 01:19 AM)
--- End quote ---
i had assumed SC is restoring from the backup but as you highlighted it is plausible that the settings are just being reset to the defaults.

Second question: is it possible that this behavior only happens after restarting the computer?
-mouser (September 03, 2013, 01:19 AM)
--- End quote ---
sometimes it happens after restarting the computer but it also happens when cold-booting the PC.

also worth mentioning, for some crazy reason i have the "start with windows" turned off within SC. instead i load SC via batchrun.

lanux128:
i had to the opportunity to restart the computer this morning, and SC had its settings reset to default. i attach the newer INI file which overwrote my custom settings. maybe it could shed some light on the cause.

ScreenshotCaptor.ini.zip (5.2 kB - downloaded 209 times.)

mouser:
There has to be something unusual about your setup that is causing this to happen.
Are you running SC portably or did you use the installer?  Have you edited your ConfigDir.ini file?

Try this:
Start SC as you normally do.  If you normally launch it automatically at boot time, turn that off while we experiment.
Then change an option, and exit SC. Restart it.  Is your change in place?

lanux128:
i have always used SC in portable mode. these are the two lines in my ConfigDir.ini

PORTABLE=TRUE
CONFIGDIR = .

--- End quote ---

i will post the results of the 2nd part when i have completed a reboot. thanks..

Navigation

[0] Message Index

[#] Next page

[*] Previous page