Main Area and Open Discussion > General Software Discussion

Program restarts, hibernations and shut downs software

<< < (4/4)

Contro:
Seems a good explanation.
Tryingggggg  :P
Best Regards
 :)

Ath:
Ja Dutch. Wonderful.
-Contro (October 06, 2012, 11:54 AM)
--- End quote ---
Sorry, as I said, haven't worked on it (or used it...) for ~10 years :tellme:

Right-click a button, choose 'Algemene instellingen...', in the first combobox select English and press the OK button.

Contro:
Bingoooooooooooooooooo
Eurekaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa


multi(0)disk(0)rdisk(0)partition(8)\WINDOWS="ST System Technics" /noexecute=optin /fastdetect /safeboot:minimal /noguiboot

This line give me the opportunity of enter in safe mode basic.

What can I automate this without need each time of modify boot.ini ?¿?¿?¿?¿¿

My boot.ini is up in this same post.
 :-*

Ath. Your program works wonderful. and I am going to try to modify that line I put before through your soft.

Best Regards
 :)

Contro:
This is from the help file about Cyclic Rebooting.  You would need to set up the Auto-Login section and enable it, then set up a shortcut in your Startup folder to the program, making sure to include the -Reboot option.  Then set the number of reboots you want on the screen and click Reboot Now to start...


"This page gives a brief description of how a PC can be set-up to reboot itself in a cycle.

Step1 – Select and save Rebooter settings
Start Rebooter and use the “Clear” button to return the reboot count to 0.
Set the ‘Maximum Reboots’ value to the number of cycles required.  <--- MY NOTE: how many times you want to reboot
Set the other parameters in Rebooter. (Reboot type, Delay, etc). Don’t set the delay value to be too short, as you want Windows to fully boot before starting the next cycle. 20 Seconds is a good value.   <--- MY NOTE: you may want it to be longer than 20 seconds!
Save the settings, with the ‘Save Options’ button.

Step2 – Create an autorun shortcut
Create an autorun short cut that points back to Rebooter executable. See the auto-run page for help on how to do this. The shortcut must use the  ‘-Reboot’ command line parameter.

Step3 – Start the cycle
Click on the “Reboot Now” button to start the cycle.

Each time Rebooter is started with the ‘–Reboot’ command line parameter, the reboot counter in incremented. Once the reboot counter becomes equal to the Maximum Reboots value no further cycles will be executed and the reboot counter will be reset to zero (ready for the next run).

-x16wda (October 06, 2012, 12:21 PM)
--- End quote ---

This perhaps was the important question I suggest at the beginning and now I have the opportunity to try modifying the boot.ini and reboots. Because logically this soft goes through the existing boot.ini.
With more or less effort, thank to your effort of course, I am beginning to get the target.
 :Thmbsup:

Navigation

[0] Message Index

[*] Previous page