ATTENTION: You are viewing a page formatted for mobile devices; to view the full web page, click HERE.

Main Area and Open Discussion > General Software Discussion

which system tray network monitor - like a graph or something.

<< < (3/5) > >>

f0dder:
Can NetWorx filter by LAN/WAN?

bgd77:
Can NetWorx filter by LAN/WAN?
-f0dder (December 04, 2009, 06:26 PM)
--- End quote ---

You can choose what network interface to monitor (if you have more than one). And there is also an option to filter out local LAN traffic:
(quote from product help http://www.softperfect.com/products/networx/manual/options_main.htm)

"The Ignore local traffic within the LAN option enables NetWorx to take into account only your Internet traffic, excluding all local communications. Technically this means that all traffic between the following addresses is ignored (these IP address ranges can be adjusted):

IPv4:
10.0.0.0 to 10.255.255.255
172.16.0.0 to 172.31.255.255
192.168.0.0 to 192.168.255.255
169.254.0.0 to 169.254.255.255

IPv6:
Link-local addresses starting with fe80:

Turning this feature on causes NetWorx to load a network driver needed for this purpose. Although the driver has been properly tested, there is always a chance of a conflict with a third-party driver that may result in a crash. If your PC becomes unstable, simply unselect this option and restart the application."

Is this what you need?

f0dder:
Is this what you need?-bgd77 (December 05, 2009, 02:13 AM)
--- End quote ---
If the filtering can be done at "show-time" rather than "capture-time" - I'd kinda like to have stats for both LAN and WAN traffic, but the ability to separate the two :)

bgd77:
It seems that you can only eliminate LAN traffic, not display both LAN and WAN traffic separately. Maybe there is another tool that can do this.

f0dder:
It seems that you can only eliminate LAN traffic, not display both LAN and WAN traffic separately. Maybe there is another tool that can do this.-bgd77 (December 05, 2009, 06:28 AM)
--- End quote ---
I used the free version of NetLimiter for a while, it has this ability - but there was something about it that didn't feel "right", dunno if it was resource consumption or the UI or whatever, it's been a while :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version