DonationCoder.com Software > Finished Programs
DONE: Sort images into folders based on resolution
hamradio:
First of all to say my congratulations to skwire who created the Dimensions2Folders which proved a powerful tool for me!
I'm a graphic designer and in combination with the Arti tool I can easily classify many images.
But the reason I came to write is that yesterday I realized that Dimensions 2 Folders shows malfunction Specifically in the uppper/lower total pixels range option fields.
First I noticed that the official site the names of the 2 fields is written upside down in relation to the application you've downloaded it ...but this is the easy part!
What concerns me more, however is that the two fields do not work at all... or i do something wrong!
Specifically I tried it and I put in the source folder 7 image which have the same aspect ratio 1:1 (150p / 300p / 450p / 600p / 750p / 900p / 1050p).
I started and gave Aspect Ratio 1:1 and Upper limit 700 pixels (lower on my case), which is to say that the source folder will be sent to the destination folder the images which do not exceed 700pixel, and in order case that will get only the first 4 images.
Unfortunately any rate i put in the Upper limit field takes all 7 files and puts them in the destination folder.
As the program don't recognizes the rate numbers i give!
Thanks again for your time. I expect is there any solution to this problem, Friendly Panos.
-PanosWare (February 28, 2016, 06:57 PM)
--- End quote ---
In the right screenshot the top field is lower limit and in the left screenshot it is upper limit. Perhaps the problem?
Not the author just something I noticed...
PanosWare:
In the right screenshot the top field is lower limit and in the left screenshot it is upper limit. Perhaps the problem?
Not the author just something I noticed...
-hamradio (February 28, 2016, 09:09 PM)
--- End quote ---
I tried tο reverse is not something happening...
hamradio:
In the right screenshot the top field is lower limit and in the left screenshot it is upper limit. Perhaps the problem?
Not the author just something I noticed...
-hamradio (February 28, 2016, 09:09 PM)
--- End quote ---
I tried tο reverse is not something happening...
-PanosWare (February 28, 2016, 09:34 PM)
--- End quote ---
Was just something I noticed...so not sure now myself...
Maybe skwire will be around to shed some light soon.
Rockets:
I started and gave Aspect Ratio 1:1 and Upper limit 700 pixels
-PanosWare (February 28, 2016, 06:57 PM)
--- End quote ---
700? 150*150 is 22500. You should write TOTAL pixels, height times width.
pepanee:
Bug Fix Needed:
Hello, I have found a tiny bug in the application Dimensions 2 Folders. Great program by the way!
But the little tiny bug that I noticed has to do with the Matches/Does not match section.
I noticed that the settings that I set in the program get saved when I close and re-open the program. But the only thing that doesn't get saved, as far as I've noticed, is the "Matches/Does not match" setting. I usually use the "Does not match" setting, so when I'm done with the program, I close it, then when I open it again, I always think that it's still saved at "Does not match".
Can you please fix that option to stay the way I last used it?
Thanks so much for the program!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version