Enable the Process Tamer log file, and check that from the GUI.

-mouser (July 08, 2018, 05:24 AM)

okay, I did that, and re-started the process.  The Log file says:

Sun Jul  8 12:31:32 2018  -> Forcing priority Above Normal due to explicit rule | acemd-918-80.exe

It's too bad that I can't tell whether one of the following two scenarios happened during last night:

1) acemd.exe stopped after finishing a job, then restarted with a new job, PT changed the priority to "above normal", and lateron, at some point of time, acemd.exe changed the priority back to "below normal".

2) acemd.exe stopped after finishing a job, then restarted with a new job, and - for whatever reason - PT did NOT change the priority to "above normal".  Although I had seen PT already once (some time yesterday) changing the priority right when acemd.exe started.

The thing is that these jobs take between 10 and 14 hours, so I don't always have a chance to watch what's happening when a job gets finished and a new one starts.  Some time this happens during the night, some time I am not at home exactly at that moment, ...

@Erich56, have you already downloaded and used the latest PT as released this week?

-Ath (July 07, 2018, 01:49 AM)

no, I havn't - since two days ago Mouser has recommended me to try the x64 beta (which I installed an hour ago and which, at least at this point, seems to work) -I didn't even know that there was a new version released this week - I had not detected a download link for it either.