11
General Software Discussion / How can I automatically run a command after an application closes?
« on: May 11, 2007, 07:16 PM »
Norton Ghost installs a windows xp service, which I assume controls its backup scheduler. But I start my backups on demand so don't need it.
The problem is, if I stop the service through WinPatrol, Ghost just starts it again next time it runs. :mad:
I've discovered I can use
to stop it - so is there any way I can make that command automatically happen once Ghost has completed its shutdown?
Thanks :D
The problem is, if I stop the service through WinPatrol, Ghost just starts it again next time it runs. :mad:
I've discovered I can use
sc stop "norton ghost"
to stop it - so is there any way I can make that command automatically happen once Ghost has completed its shutdown?
Thanks :D