topbanner_forum
  *

avatar image

Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
  • Thursday March 28, 2024, 12:08 pm
  • Proudly celebrating 15+ years online.
  • Donate now to become a lifetime supporting member of the site and get a non-expiring license key for all of our programs.
  • donate

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Squeaky [ switch to compact view ]

Pages: [1]
1
Mouser's Zone / Re: Error upon installation and when running.
« on: July 07, 2014, 12:05 PM »
My "guess" is for some reason my admin priveledge had changed from Administrator to Debugger. I find that happens at times and my system always acts up when it does. It probably caused an incorrect installation.

2
Mouser's Zone / Re: Error upon installation and when running.
« on: July 07, 2014, 10:39 AM »
Ok,

I figured it out. Maybe this will help someone else. I managed to take a snapshot of the save error message using my IPhone. It was saying that it could not create the directories it needed in order to save properly. I opened My Documents folder and created the DonationCoder folder, ScreenshotCaptor subfolder, and Older subfolder.

All errors have disappeared.

Thanks!

3
Mouser's Zone / Error upon installation and when running.
« on: July 07, 2014, 10:02 AM »
Hi,

I recently installed Screenshot Captor. Whenever I run the program I get the error, "There is no disk in the drive. Please insert a disk into drive \Device\harddisk2\DR2." It gives me the options of Cancel, Try Again, and Continue. Whatever I hit it will cycle through Hardisk 2-4, and DR2-5. After about 30 clicks or so it will disappear and then allow me to use the program. It will pop up at other times throughout the capture process and again will demand 30 clicks or so before I can continue. I have read about similar issues here but nothing that was pertinent enough.
Also, I noticed that if I change anything in the preferences I see an error saving message pop up at the tray icon, but it goes by too fast.


My system is Windows 7 64 bit. I am the administrator of my PC. I have gone through all of the preference options and tried de-installing and re-installing.

Other than that, wonderful program.

Thanks!

Pages: [1]