Thanks for the explanation...looking forward to it.

It does work.  Would be nice to integrate it into SC, though.

Dear cranioscopical,
I apologize to the forum members if I seemed discourteous.
This program is worlds better than any similar one, so I use it daily.
My problem is there is no option to show the current printer, nor is there one to each time reset the printer to the default, if it were changed previously.
Using multiple large format printers on occasion can be costly, and inadvertently printing to what was thought to be a b&w laser occasionally results in a costly mistake.
I have been asking mouser to add either one of these options.
Thanks to c.gingerich, I have a temporary workaround.
I am just hoping it could be made permanent by integrating it into the program.
Respectfully,
omegadoc