ok, now every row is checked when adding a sfv, so thats good.

i have noticed the slowdown when trying to scroll down or up.

so end results are:

total: 31/31        ok: 28        bad: 1        missing: 2

so the total is just confirming the rows?

one other minor thing which might be a little hard to explain. i use the scroll wheel on the mouse quite a lot and when i open the program, the cursor default is on the mode menu. so if i add the files then start scrolling, the mode changes because i haven't clicked elsewhere in the program.  :-[

also, maybe have the counters reset after clearing the list. at the moment, they are reset only once a new verify begins.

oooh, of course.. the sfv itself isn't getting checked.  :-[

but wouldn't most people clear the files in the list before adding some more folders? thats what i do. i plan to check one hard drive, once the verify is complete, remove files from list, grab another hard drive and do the same for that. if the list is cleared it gets reset back to zero. its just that if i added 30 folders, i would expect there to be 30 sfvs, so it would be confirming that they were all picked up.

if it can't be done, then it's ok.  ;)

wow skwire, i wasn't expecting a release so soon.  :Thmbsup:

the row colors aren't too harsh but they still stand out which is good and is what i am looking for.

you forgot to add the sfv total at the bottom of the screen along side the other counters.

another thing i have noticed is, when i use "scan folder for checksum files and load" it loads the sfv but it won't check the row which has missing files. so if i verify all files, the counter at the bottom still shows 0 missing at the end of the check (the row is highlighted as missing though which is fine). so at the moment i have to remember to "check all rows" option before running the verify. could you make it default to "check" all the rows when adding the sfv?

thanks a lot.