5
« on: December 21, 2014, 11:03 AM »
@theGleep: Hmm..... I KNOW I replied several days ago to your post as I was getting ready to head out the door the other day, but I did so on my desktop, which badly could use reformatting, and it must've locked up. Kinda sad my iPhone is faster than this thing...
You're dead on regarding the flake to alcohol ratio. It will take a few days to completely dissolve, but it will. When it does, I'd bet it is already thin enough to spray, depending on your rig. If your gun is high pressure, low volume, Harbor Freight has a detail HVLP detail gun for under $20-$25 bucks that works great. I strongly advise adding a water filter to the line. I haven't sprayed shellac through my gun yet, but after this bass, I highly suspect I will. When it comes to brushwork, I'm no DaVinci, and it gets old sanding the lines down. I haven't had time to work on it for a week, knowing I won't be ordering the remaining parts until after the first of the year, so I haven't been feeling the rush to do so with Christmas at the doorstep.
You should be able to put coats on fairly quickly, given the speed the alcohol evaporates. I can't really give you a number to shoot for, it all depends on how thick you coat it each session, I would block sand by hand, so you don't risk going into the stain from oversanding, and remember that once you've got no shiny pits or valleys when you've sanded as close as you dare, you are glass smooth. Spray a couple more coats on to have a good base for polishing, and after curing, you will be set for either the Arm-R-Seal or your car polish, depending on your preference.
I'll look NOW for that invoice, I have at least one of the forms I'm looking to put in a program somehow, I may have to explain it in the email. My computer is acting up, so I need to get this posted. Good luck and Merry Christmas!