I have been getting a lot of BSODs recently and began to wonder if it was a memory problem.
I ran a memory tester and it found some errors on one of my two memory cards (I had 2 x 512Mb DDR PC2100 cards in there).
The strange thing is if I put in either card by itself it tests fine, but if I put two in (in any slot combination) I seem to get errors.
I have just ordered a replacement 1Gb card (so that I only need one card installed) but wonder if anyone has any ideas how to fix the problem.
It doesn't seem to be a slot problem because I can move a single card around and it works fine!
All BIOS timings are set to conservative defaults.











Logged






Hope to see you all later!

- carpe noctem