Main Area and Open Discussion > General Software Discussion
I Need DC Input
CleverCat:
Drive letters messed up in Disk Management....
4wd:
Drive letters messed up in Disk Management....-CleverCat (March 03, 2012, 04:53 AM)
--- End quote ---
What do you mean by "messed up" ?
Whichever installation of Win7 you boot off will become drive C.
In your BIOS you need to set which drive to boot off normally.
BIOS->Advanced Setup->Hard Disk Drives and then move the drive you want it to boot from to the top of the list.
Is there any chance of a picture of the POST screen, (the one where it says 'Press Del to enter SETUP') ?
Also the Advanced Setup menu in BIOS would be nice, (I think you have a later version than what's shown in the manual).
You can set the BIOS to normally boot off the Seagate and then run EasyBCD and add an entry for the Win7 installation on the Maxtor:
As easy as:
1) Select Add New Entry
2) Select the drive letter for the Maxtor
3) Add Entry
EDIT: Dammit! You replied before I could add the picture.
CleverCat:
Okay - couldn't change bios to boot from Maxtor but used EasyBCD and iReboot and booted into old drive no problem! :Thmbsup:
I see letters have changed now I'm on old drive...
Will check bios now to see if it's changed? Will take pic and post....
:D
CleverCat:
BRB ;D
CleverCat:
;D ;D ;D
Will post bios pics tomorrow - gotta go shower ;)
You can go to bed now! :Thmbsup: :D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version