Main Area and Open Discussion > Living Room
favourite hardware hacking resources
Stoic Joker:
The trick is Duct Tape and WD 40
If it moves, but shouldn't = Duct tape
If it doesn't move and should = WD 40
No other problems exist
-Fred Nerd (May 22, 2011, 06:39 AM)
--- End quote ---
He's got a point there... ;D
Target:
The trick is Duct Tape and WD 40
If it moves, but shouldn't = Duct tape
If it doesn't move and should = WD 40
No other problems exist-Fred Nerd (May 22, 2011, 06:39 AM)
--- End quote ---
He's got a point there... ;D-Stoic Joker (May 22, 2011, 07:38 AM)
--- End quote ---
what about electrical/electronic 'projects'?
one squirt of wd and you'll need either a fire extinguisher (if you got this far I suspect you probably keep one handy at all times) or a defribrillator (though you could use that coat hanger in the wall socket)
Renegade:
The trick is Duct Tape and WD 40
If it moves, but shouldn't = Duct tape
If it doesn't move and should = WD 40
No other problems exist-Fred Nerd (May 22, 2011, 06:39 AM)
--- End quote ---
He's got a point there... ;D-Stoic Joker (May 22, 2011, 07:38 AM)
--- End quote ---
what about electrical/electronic 'projects'?
one squirt of wd and you'll need either a fire extinguisher (if you got this far I suspect you probably keep one handy at all times) or a defribrillator (though you could use that coat hanger in the wall socket)
-Target (May 22, 2011, 06:08 PM)
--- End quote ---
In those cases it's obvious... No moving parts. Plaster them with duct tape! ;D
Stoic Joker:
The trick is Duct Tape and WD 40
If it moves, but shouldn't = Duct tape
If it doesn't move and should = WD 40
No other problems exist-Fred Nerd (May 22, 2011, 06:39 AM)
--- End quote ---
He's got a point there... ;D-Stoic Joker (May 22, 2011, 07:38 AM)
--- End quote ---
what about electrical/electronic 'projects'?
one squirt of wd and you'll need either a fire extinguisher (if you got this far I suspect you probably keep one handy at all times) or a defribrillator (though you could use that coat hanger in the wall socket)
-Target (May 22, 2011, 06:08 PM)
--- End quote ---
Actually, WD40 does work quite well for displacing moisture from wet (or mildly corroded) wiring. It was frequently used back in my junkyard days on wiring harnesses that had been pulled from a parts bike. Squirt a little in each of the multi-pin plugs before assembly and all works well.
It's flammable yes, but completely non-conductive (paraffin based).
Target:
In those cases it's obvious... No moving parts. Plaster them with duct tape! ;D-Renegade (May 22, 2011, 06:11 PM)
--- End quote ---
congratulations, you have exceed all the requirements for joining our helpdesk team!!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version