Other Software > Announce Your Software/Service/Product
Bvckup
andhar:
@apankrat: thanks for your reply :)
But it doesn´t work.
My file listing is as follows:
--- ---.bmx <DIR>
SomeOtherDir <DIR>
file1.bmx
file2.bmx
file3.bmx
I set the filters as you wrote but it ignores the rule for the ".bmx" folder. For now I stick with it by entering the .bmx folder into the "location" field and let it exclude *.* of the content of the dir. I then just have an empty ".bmx" dir on my backup drive.
MerleOne:
Could you show make a capture of the exclusion window and post it here ?
MenzAgitat:
Hello
I have been using DSynchronize for over 2 years and just discovered Bvckup.
What I like :
- reliability (DSynchonize does only monitor changes but assumes all is already synchronized, which is not always true, and sometimes stopped to work without apparent reason)
- small cpu usage when syncing
- separated interval setting for each backuped place
- readability of the GUI
What I dislike :
- DSynchronize was able to start as a service (without GUI) and didn't use more than 2 or 3 MB of memory (about 100Go of data to monitor in numerous places) while Bvckup uses about 90-100MB to monitor the same places.
Very good work; if you could reduce memory usage, it would be near perfect.
andhar:
Could you show make a capture of the exclusion window and post it here ?
-MerleOne (October 20, 2010, 04:15 AM)
--- End quote ---
sure :)
MerleOne:
sure :)
-andhar (October 20, 2010, 07:31 AM)
--- End quote ---
Could you try entering also the locations, if possible ?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version