DonationCoder.com Software > ProcessTamer
Non Admin usage
(1/1)
telemarker:
Process Tamer properly runs in Admin mode only as far as i know.
When I start it as poweruser, no processes are shown.
When I start it as admin ("Run as") it shows only admin processes, not the programms I run as poweruser.
Is there a way to avoid this or are all of you really so careless to work as admins? ,
Brgds.
Steffen
mouser:
Process tamer should always find all processes.
But keep in mind that by default in the display it only shows processes that are eating up a non-trivial amount of cpu or that have unusual process priorities.
To show ALL processes, uncheck the box marked "Hide < 1% Normal CPI" at the bottom:
Let me know if that solves your problem.
Navigation
[0] Message Index
Go to full version