Main Area and Open Discussion > General Software Discussion
RE-PACK setup.exe
hulkbuster:
Hello folks , once again. i need a small help here,,,,i had some setup.exe warez, and i was thinking if i could re-pack the setup.exe, after installation back to setup.exe. (fully working)
Since i usually dont remember n tend to delete them, from my Folder n Recycle Bin.
Any help would be greatly appreciated.
Really like www.donationcoder.com , :Thmbsup: :Thmbsup: :Thmbsup:
scancode:
Hello folks , once again. i need a small help here,,,,i had some setup.exe warez, and i was thinking if i could re-pack the setup.exe, after installation back to setup.exe. (fully working)
Since i usually dont remember n tend to delete them, from my Folder n Recycle Bin.
Any help would be greatly appreciated.
Really like www.donationcoder.com , :Thmbsup: :Thmbsup: :Thmbsup:
-hulkbuster (August 21, 2009, 01:14 PM)
--- End quote ---
I'll just ignore the 'warez' part. There's no easy way to do that, but you could use NSIS: export the app's registry settings, then use REG2NSIS, then replace the absolute paths for NSIS variables, and then write a simple installer script.
Another option would be a SFX archive and a small batchfile.
Cheers.
hulkbuster:
export the app's registry settings, then use REG2NSIS, then replace the absolute paths for NSIS variables, and then write a simple installer script.
--- End quote ---
Can u elaborate a little, cause i m new to ( NSIS & REGNSIS ) , however once i came across uharc(compressor) for creating SFX...
but to export app's registry is a new thing. Hope i m not asking too much of ur time....
Thank u
scancode:
export the app's registry settings, then use REG2NSIS, then replace the absolute paths for NSIS variables, and then write a simple installer script.
--- End quote ---
Can u elaborate a little, cause i m new to ( NSIS & REGNSIS ) , however once i came across uharc(compressor) for creating SFX...
but to export app's registry is a new thing. Hope i m not asking too much of ur time....
Thank u
-hulkbuster (August 22, 2009, 02:13 AM)
--- End quote ---
No problem. I'll make a video tutorial, but you'll have to forgive my sucky english :)
hulkbuster:
No problem , i can wait.... :D :up:
Navigation
[0] Message Index
[#] Next page
Go to full version