17
« on: December 07, 2014, 04:40 PM »
@tjbray: I'm actually fully prepared for this to not look as super-awesome-cool as it might if someone else did it - I'm gonna be proud of it because *I* did it :)
But I am hoping that the "character" the torch/heat gun added will help it look better. :)
Thanks and thanks in advance for all of your advice! I will *definitely* post pictures.
So - I have stain prep, stain and shellac. (Don't *have* the shelac, yet - gonna buy it just before I put it on).
I have a wire hanger I plan to hang it (through the holes that mount the neck to the body) with - should I hang it through the *whole* finishing process? If I take it down to sand it (can't imagine *not* doing so), would it be okay if I'm wearing jeans, or should I buy a tyvek suit?
So far, I've been sanding "bare handed". I have a box of neoprene gloves - should I re-sand with the gloves on before I stain prep?
Then, should I do the ((alcohol + sand) * 3) bit before the stain prep, or after, or both?
Would everclear (95% grain alcohol) work in place of denatured alcohol?
When it's time to stain, I should do the ((alcohol + sand) * 3) thing before I apply the stain? Or should this be *after* staining, but before shellacing?
When it's time to shellac, I do a lot of as-thin-as-I-can coats, right?
Thanks again for the advice!