topbanner_forum
  *

avatar image

Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
  • July 23, 2019, 02:19 AM
  • Proudly celebrating 13 years online.
  • Donate now to become a lifetime supporting member of the site and get a non-expiring license key for all of our programs.
  • donate

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - carlo133 [ switch to compact view ]

Pages: [1]
1
Mouser's Zone / Re: MiniCap Printer
« on: September 14, 2016, 08:46 AM »
Tnks! I Will test it!  :D

2
Mouser's Zone / MiniCap Printer
« on: August 22, 2016, 10:32 AM »
Hi, I still using your beatiful MiniCap software to capture and print the PC screenshot by using the commandline commands.
Everything works properly, but there is one thing that I do not understand: the printouts images on paper are smaller than the printout images obtained with the standard Print Screen command.
In the MiniCap -printpreview the defaults sets for the print margin is 1 inch.
Is there a way to set a lower margin value ad default, (close to zero), via commandline or by any ini command?
Thanks, Carlo.

Pages: [1]