topbanner_forum
  *

avatar image

Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
  • December 14, 2018, 08:43 AM
  • Proudly celebrating 13 years online.
  • Donate now to become a lifetime supporting member of the site and get a non-expiring license key for all of our programs.
  • donate

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - waldnerm [ switch to compact view ]

Pages: [1]
1
Hi,

Thanks for the response, after trying a few combinations I found one that works.  I didn't think that it was that Oxygen was blocking the Print Screen key, I thought that it would not release focus ( based on some other issues I had read about ), but it does look like it is the key stroke.  That was a rookie mistake on my part, I should have investigated both items before submitting a post.

Thanks for your help,  Mel

2
Hi,

I am using v4.21.1 and have run into an issue with SC and the Eclipse Oxygen IDE.  I have the Print Screen key mapped to select a region which is then copied to the clipboard.  What happens when Oxygen has focus is that SC will not \ can not respond to the Print Screen key, it appears that Oxygen is either blocking the focus change or the key stroke.  I believe this is an Oxygen issue as the previous Eclipse IDE version, Neon, did not have this behavior.

I posted this as a question in the Eclipse forum, but I am wondering if there is anything that I can do in the SC setting to allow it to "grab" focus when the Print Screen key is used ? I scanned the settings and there wasn't anything that was obvious to me that would help.

Any feedback or suggestions would be appreciated.

Thanks!   Mel

Pages: [1]