Messages

1

FlipSuite and Flipbook Printer / Re: Using 'Custom' Cardstock or Paper size

« on: January 11, 2006, 01:15 PM »

I found it. It was printing right-stage middle on the letter size page.
How's your end coming, mouser?

2

FlipSuite and Flipbook Printer / Re: Post your card stock templates here

« on: January 11, 2006, 01:13 PM »

This worked for me on an HP 3120 with 3 x 5 inch index cards.

3

FlipSuite and Flipbook Printer / Re: Using 'Custom' Cardstock or Paper size

« on: January 10, 2006, 01:20 PM »

Either that or add common index card sizes to your list of paper sizes and take out custom.
Thanks

4

FlipSuite and Flipbook Printer / Re: Using 'Custom' Cardstock or Paper size

« on: January 10, 2006, 01:05 PM »

I get a blank card.
I printed out a full sheet to find out where the program is printing it but my printer is handling the index cards differently so it doesnt seem to matter.
i.e. the printer prints on the index card what is in the center of the letter size paper relation-wise. Or maybe it's in the lower left; that's what I haven't figured out yet.

5

FlipSuite and Flipbook Printer / Re: Using 'Custom' Cardstock or Paper size

« on: January 10, 2006, 12:33 PM »

This is what I was talking about in my original post. Adjusting all that doesn't adjust the size of the paper being printed on in the program.

This is before switching to 'Custom' paper size. (Paper size is still set to 'Letter')



This is after. Note that the program has still not been told what size 'Custom' is.



HTH

6

FlipSuite and Flipbook Printer / Re: Using 'Custom' Cardstock or Paper size

« on: January 10, 2006, 10:57 AM »

If I understand you correct, I make the 'Label Height' and 'Label Width' measurements match the size I want the image on the index cards. Then -- by trial and error through test page printing -- I move the image onto the card by modifying the 'Offset X' and 'Offset Y' values.

7

FlipSuite and Flipbook Printer / Using 'Custom' Cardstock or Paper size

« on: January 09, 2006, 11:59 PM »

Flipbook Printer doesn't seem to be able to handle other cardstock sizes.

I purchased ~1000 3" x 5" index cards to print a flipbook or 3. How do I use them in Flipbook Printer? If I choose 'Custom' for Paper size, where do I tell it what size 'custom' is?

Thank you